The radionic practitioner seeks to selectively predispose objects or events through extra-physical channels of influence. This premise is closely allied with spiritualist endeavours such as clairvoyance and telekinesis. The point of departure is enlistment of electronically-inspired instruments to augment solitary mind power. Its origin can be traced to early 1900’s alternative therapists who drew an analogy between energy healing and the emerging science of radio broadcast.
A typical tuning procedure is as follows. An item or substance closely linked to the intended target is inserted within a receptacle upon the control panel. The desired outcome is visualised while fingertips of one hand are rubbed in a circular motion upon a plate of acrylic perspex or latex rubber. The first in a series of tuning dials is then rotated with the other hand until an involuntary “grabbing” sensation on the plate indicates the correct position. This is repeated in sequence on all dials present. If no grab is detected, that respective knob is left at “0”. An additional dial labeled “intensity” enables a 0-10 quantitative readout to be obtained relating to any proposed function of the device.
The grabbing, or “stick”, is caused by activation of cutaneous sweat glands in response to alignment between an actual and purposefully imagined truth. It is a mode of biotransduction related to that of conventional lie detection equipment, but broadened in scope to extract information from a deeper and more pervasive level of awareness. The latter may be equated to a global consciousness or “planetary mind”, this being the neuro-energetic phenomena that defines the reality in which we collectively participate.
Over the millennia, ritual invocation has relied upon a wide variety of support mechanisms ranging from found objects to massive temples. A common thread is deliberate integration with the psychic momentum of a prevailing belief system. Underpinning this trend is an innate human capacity to engage with pre-material domains and implant within them sustainable patterns of energy. Through conscious participation or otherwise, imaginary constructs eventually acquire sufficient density to precipitate into solid form.
To effect tuning, radionic instruments typically incorporate two or more manually rotatable components. Most common today are off-the-shelf, variable resistors (potentiometers, “pots”), centered beneath a numerically indexed dial face. Their radial geometry harkens to ancient structures such as stone circles and Native American medicine wheels. In comparison, radionics offers the advantge of portability and self-power. It replaces ceremonial performances with dials, and the force of upwelling Earth energy with magnetic or electrical current. As particles of the latter pass through the tuners, they acquire a “memory” of their physical path in the universal language of altered spin potentials. Upon superposition with the intended recipient, either present or non-local, this self-extracts as the operator’s intended effect.
A highpoint of radionic evolution was the condensor-tuned, amplified devices first built by Dr. Galen Hieronymus in the 1930’s. The design at the beginning of this article utilises his efficient 0-100 two dial tuning system, in conjunction with a few instructive features. Pots are configured to mimic the now scarce plate condensors. As a mode of tuning, they adjust the distribution of north and south magnetic “particles” passing through the caduceus coil. Sensitive Barium Titanate (BaTio3) capacitors interface with ambient energy fields. The figure eight (“mobius”) coil functions as a vector balanced transmitting antenna.
For obvious reasons, we cannot endorse for actual therapy any method that relies, even in part, upon learned subjective abilities. However, there exist countless other potential applications, as indicated by the following practical example.
There is a favourite plant in your yard that appears ill. Place a leaf in the instrument’s well. Then slowly rotate the “intensity” knob from 0 to 10 while asking for the current level of vitality. Stop turning when a positive “grab” provides a quantitative readout. Turn the knob back to “0”. In a similar fashion, the effect of any proposed remedy may be known in advance by placing it in the well along with the leaf.
Next form a stable mental image of the plant in perfect health while slowly rotating the first rate knob from 0 to 100. Repeat with the second rate knob. Leave the instrument for an hour and then recheck the vitality for any improvement. Unlike referring to published rate lists, this streamlined technique seeks to automatically encompass all prevailing factors, without the necessity for detailed analysis or specialised knowledge. Once a positive response is confirmed on an energy level, application should be not continuous but rather periodic throughout the day to avoid acclimatisation to the projected influence.
Above is a sample page of two-dial agricultural rates according to Dr. Hieronymus. Note that some require accuracy to quarters of a dial increment, thus necessitating a very sharp pointer knob. It none can be found, drill a hole in the side of any knob and glue in a short length of sewing pin or similar. The next most prominent tuning system, popularised by the British dowser George de la Warr, employs 0-10 indexing. This requires each individual tuning to occupy up to nine dials. Photos of numerous instrumented concepts may be viewed in the Image Gallery to the right.
The “rate” and “intensity” dial faces above reflect the standard carbon potentiometer arc of a full 270 degrees. Its extremes of travel must coincide precisely with the first and last numerical increments. Due to manufacturing variations, this may not always occur. One solution is to employ a vector graphics computer program to compress or stretch the artwork. When choosing a pot, prefer the larger common diameter, with a smooth 1/4″ diameter shaft and grub screw to allow easier alignment with the dial scale.
Anyone consulting a published rate book will notice both positive and negative items are listed. To accommodate this, a DPDT pole reversing switch can be inserted between our instrument’s transformer and mobius coil. Thieir common connections can then be swapped from those shown in the diagram to neutralise, rather than summon, the dial-specified object or condition.
Science or Magic?
It is sometimes asked if radionics is functional hardware or simply an arbitrary focus for creative intent. The reader may by now appreciate that, while obeying slightly different “laws”, these protocols are complementary rather than mutually exclusive. For example, one clear advantage of a physical device is that it can be tuned and then for a time “forgotten”. This provides isolation from conceptual bias, self-interest and limitations upon personal vitality that might otherwise pinch off the energetic pathways required for successful operation.
Ideally, any “reality engineering” should attempt to align its intent and motive force with a plausible sequence of events. Trying to grow melons on a blade of grass would require such an immense reorganisation of the supporting ethers as to be not worth attempting.
Further insight into the creative dynamics between mind and matter may be obtained from elements of modern quantum physics such as particle entanglement, vacuum polarisation and the Many Interacting Worlds Theory (MIW). For a balanced historical perspective on the topic at hand see Edward Russell’s the excellent book, “Report on Radioncs”. Readers interested in building a “classic” 9 or 12 dial instrument, as manufactured by De la Warr Labs and others, can find photos of their inner circuitry in our image gallery.
Keywords; Radionic instrument, PSIonics, Dowsing, Radiaesthesia, Homeopathic potentiser, Morphogenic field, Biosignatures, Stochastic electrodynamics, Particle entanglement, Berry’s Phase, Action-at-a-distance, Non-locality, Dean Radin, Tiller imprint, Quantum mind, Particle pair production, Mobius coil, Albert Abrams, Ruth Drown, George de la Warr, Galen Hieronymus, Eloptic energy, Cosmic pipe, Pathoclast, UKACO agriculture